We offer various post-production services here for our anti-slip and marking tape. In this blog post, we discuss our custom sheeting service.
Not all of our customers want a roll based anti-slip tape. Some require large sheets or strips to specific lengths and widths in bulk. While this would be possible for the customer do, it would be more time consuming for them than for us to do it. With our large anti-slip tape sheeters, controlled using fully computerised PLC ( Programmable Logic Controller ) systems that make it very easy for us to cut our products to specific tolerances for our customers. This allows them to receive the product ready for immediate use if necessary.
Much like our crush cutters, Heskins anti-slip sheeters cut products with the same blade, but only one compared to multiple on the crush cutters at one time.
This means that one blade will cut twice every few seconds, rather than long runs cutting large lengths of abrasive tape like the crush cutter. The blade lasts a lot longer and is much more cost-effective to run. However, being for a slightly different purpose means that the two machines and services are incomparable, as they both serve their different purpose as efficiently as possible.
Heskins anti-slip sheeters have been fine-tuned so they cut all Heskins products cleanly and do so to an accuracy of within 2mm. From Heskins marking tape to the thickest, most abrasive material, you can be guaranteed that you will receive a cleanly cut product ready to apply onto any clean, dry surface.
For more information on the range of services we provide, you can visit the services page, or alternatively get in touch with us via live chat, phone or the contact us form on the website.
Want to Stay Up to Date?
Subscribe to future blog posts and newsletters here.